Switch 1: Fiber mode switch
L>" > @> " QR"S " > >
"@"QRS"C"G
Note: be sure the opposite end is using the same setting (Forced or
Auto-negotiation). And when using two converters at the same time,
the two converters MUST set to forced mode.
Switch 2: LLR
L>" > @> " QR"S " > > <<9
""QRSG
Note: When using two converters, don’t enable the both devices’ LLR
function at the same time.
INSTALLING IN A CHASSIS
> "#@"""E>PD"""F
@>G
H">@"#"@DD>>@>K
Step 1.I"@"D>@"#G
Step 2.C">"E>#@"G
Step 3.H>@"#">@">@@
G
4
To Next Page
Loading...
