D-Link DSR-1000AC - Preface; Manual Revisions

About This Guide
This guide gives step by step instructions for
setting up DLink DSR1000AC Wireless AC
Services Router. Please note that the model
you have purchased may appear slightly
different from those shown in the illustrations.
Unpacking the Product
Open the shipping carton and carefully unpack
its contents. Please consult the packing list
located in following information to make sure
all items are present and undamaged. If any
item is missing or damaged, please contact
your local DLink reseller for replacement.
 One (1) DSR1000AC Wireless AC Services
Router
 One (1) Power adapter
 One (1) Console Cable (RJ45toDB9 Cable)
 One (1) Ethernet (CAT5 UTP/Straight
Through) Cable
 One (1) Reference CD (CDROM containing
product documentation in PDF format)
 Two (2) Rack Mounting Brackets
 Three (3) Detachable Omnidirection
antennas
Product Overview
Front Panel - DSR-1000AC
Figure 1. DSR-1000AC Front Panel
# Item Description
1 LED
(Top to
bottom)
Power LED: Indicates the
Wireless AC Services Router is
powered on.
5GHz WLAN LED: A solid light
indicates that the wireless
segment is ready. This LED
blinks during wireless data
transmission.
2.4GHz WLAN LED: A solid light
indicates that the wireless
segment is ready. This LED
blinks during wireless data
transmission.
2 USB Port It can support various USB 1.1 or
2.0 devices below:
1. Flash Disk or Hard Disk for
network sharing.
2. 3G Adaptor for WAN
redundant.
3. Printer.
3 Gigabit LAN
port (14)
Connect Ethernet devices, such
as computers, switches and
hubs.
4 Gigabit WAN
port (12)
Two auto MDI/MDIX WAN ports
are the connection for the
Ethernet cable to the cable or
DSL modem.
The WAN2 port is a configurable
port which can support WAN2 or
DMZ port for dual WAN
connections or internal Server
Farm purpose.
5 Console Port Used to access Command Line
Interface (CLI) via RJ45toDB9
console Cable.
Table 1. DSR-1000AC Front Panel Descriptions
Device Status LEDs and Ethernet Port
LEDs
Figure 2. Ethernet RJ-45 Port LEDs
The device LEDs show information about
current device status. When the device power
up, the POWER/STATUS LED will show solid
orange during power on process. Startup takes
one minute approximately to complete, the LED
will change to solid green. If you want to turn
the device off and on again, we recommend you
wait a few seconds between shutting it down
and powering it back. The Ethernet LEDs show
the status of each Ethernet port. Table 2 lists
the name, color, status and description of each
device LED.
DLink Wireless AC Services Router