D-Link DSR-1000AC - Page 5

Browser Version
Microsoft Internet
Explorer
6.0 or higher
Mozilla Firefox 3.5 or higher
Netscape
Navigator
9.0 or higher
Apple Safari 4.0 and later
Google Chrome 3.0 and later
Table 4. Browser Compatibility
To access the device with the WebUI:
1. Connect your workstation on the port labeled
LAN (14), which is preallocated to the LAN.
2. Ensure your workstation is configured with a
static IP address in the 192.168.10.0/24 subnet.
Note: Disable popup blocking software or add
the management IP address
https://192.168.10.1 to your popup blocker’s
allow list.
3. Launch your browser, enter the IP address
for the LAN interface (the factory default IP
address is https://192.168.10.1 (for DSR Series
routers with WW firmware) or
http://192.168.10.1 (for DSR Series routers with
RU firmware)), then press Enter.
Figure.6 Browser Address
4. Log on the Wireless AC Services Router Web
Interface The default log on information is:
Username: admin
Password: admin
Figure 7. Authentication Message
Using a Console Connection
(RJ45-to-DB9 DCE)
The Wireless AC Services Router provides an
serial port that enables a connection to a
computer or terminal for monitoring and
configuring the device. This port is a RJ45
connector, implemented as a data
communication terminal equipment (DCE)
connection.
To use the console port connection, you need
the following equipment:
1. A terminal or a computer with both a serial
port and the ability to emulate a terminal.
2. A RJ45toDB9 RS232 with female
connector. (Already included in packing list).
3. If your Laptop or PC doesn’t have RS232
connector, a converter is required.
Note: DSR1000AC does not come with RS232
converter and these must be purchased
separately.
To establish a console connection:
1. Plug the RJ45 connector of the supplied
RJ45toDB9 cable directly to the console port
on the Wireless AC Services Router.
2. Connect the other end of the cable to a
terminal or to the serial connector of a computer
running terminal emulation software. Set the
terminal emulation software as following:
Baud rate: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
3. When you have correctly set up the terminal,
having previously followed the instructions in
section 2.3, “Connecting Power and Turn the
Device On/Off” then switch on your device. The
boot sequence appears in the terminal.
4. Once the boot sequence completes, the
command prompt is displayed, the device is
ready to be configured.
Finalizing the Configuration
After initial setup, you should refer to the
companion publications found in PDF format on
the accompanying master CD for more
information on how to begin to configure the
DSR1000AC device.
DLink Wireless AC Services Router