D-Link DSR-500N - Open VPN; Settings; Server

D-Link DSR-Series User Manual 117
Section 7 - VPN
Open VPN
VPN > OpenVPN > Settings
OpenVPN allows peers to authenticate each other using a pre-shared secret key, certicates, or username/
password. When used in a multiclient-server conguration, it allows the server to release an authentication
certicate for every client, using signature and Certicate authority. An OpenVPN can be established through
this router.
You can select server mode, client mode, or access server client mode. In access server client mode, the user has
to download the auto login prole from the OpenVPN Access Server and upload the same to connect.
Server
Settings
Field Description
Mode Select Server.
VPN Network Enter the IP network for the VPN.
VPN Netmask Enter the netmask.
Port Enter what port to use. The default port is 1194.
Tunnel Protocol Select either TCP or UDP.
Encryption Algorithm Select the encryption algorithm from the drop-down menu.
Hash Algorithm Select the hash algorithm from the drop-down menu.
Tunnel Type
Select either Full Tunnel or Split Tunnel. Full Tunnel mode just sends all trac from the client across the
VPN tunnel to the router. Split Tunnel mode only sends trac to the private LAN based on pre-specied
client routes. If you select Split Tunnel, refer to “Local Networks” on page 120 to create local networks.
Save Click Save to save and activate your settings.
To congure the router as an OpenVPN Server:
1. Click VPN > OpenVPN > Settings.
2. Toggle OpenVPN to ON and complete the elds in the table below.