D-Link DWL-3200A - Rogue AP Detection Commands

802.11 a/g Dual Band Access Point Command Line Interface Manual
18
rstp setstp Modify Spanning Tree Settings rstp setstp maxage [6 – 40]
rstp setstp hellotiem [1-10]
rstp setstp forwarddely [4-30]
rstp setstp priority [0-61440], (note: 0i shte highest)
rstp setstp version [1:2], (note: 1 is st)p and 2 is rstp)
rstp setstp txholdcount [1-10]
rstp setstp fbpdu[0-:1], (note: 0 is disduble and 1 is enable)
rstp getstp Show Spanning Tree Settings rstp getstp
rstp setport Modify STP Port Settings
, includes cost , priority, edge, p2p and state
parameters
rstp setport
rstp getport Show STP Port Settings rstp getport
rstp setdefault Set Factory Default rstp setdefault
Rogue AP Detection Commands
rogue add Add a Rogue Access Point Result Entry rogue add <index>
rogue del Del a Rogue Access Point Result Entry rogue del <index>
rogue deleep Del a Rogue Access Point Result Entry rogue deleep <index>
rogue list Display Rogue Access Point Detection Result rogue list
rogue listeep Display Rogue Access Point Detection Result rogue listeep