802.11 a/g Dual Band Access Point Command Line Interface Manual
4
When you enter a command without all of its required parameters, the CLI will prompt you with a list of possible completions. For example, if “tftp” was entered, the following screen
opens:
This screen displays all the possible command completions for “tftp”
When you enter a command without a variable or value that needs to be specified, the CLI will prompt you with further information about what is needed to complete the command. For
example, if “snmp authtrap” was entered, the following screen opens:
The missing value for the “snmp authtrap” command, “enable/disable,” is displayed in the screen above.
To Next Page
Loading...
