26
Using the Configuration Menu
WMM:
Select Enable or Disable, Disable is selected by default. WMM
stands for Wi-Fi Multimedia, by enabling this feature it will improve
the user experience for audio and video applications over a Wi-Fi
network.
Preamble:
Select the default value Short and Long, or Long Only.
RTS Length:
Transmit Power:
This value should remain at its default setting of 2346. If you
encounter inconsistent data ow, only minor modications to the
value range between 256 and 2346 are recommended
Choose full, half (-3dB), quarter (-6dB), eighth (-9dB), minimum
power.
Wireless B/G Mode:
This function allows you to congure the wireless network with IEEE
802.11g only, IEEE 802.11b only, or IEEE 802.11g with backward
interoperability with IEEE 802.11b.
Enable data rate control:
Specify the data rates at which the DWL-3260AP should transmit
signals. Choose from 6Mbps, 9Mbps, 12Mbps, 18Mbps, 24Mbps,
36Mbps, 48Mbps, 54Mbps.
The fragmentation threshold, which is specied in bytes, determines
whether packets will be fragmented. Packets exceeding the 2346
byte setting will be fragmented before transmission. 2346 is the
default setting
Fragment Length:
Super G Mode:
Super G is a group of performance enhancement features that
increase end user application throughput in an 802.11g network.
Super G is backwards compatible to standard 802.11g devices.
For top performance, all wireless devices on the network should be
Super G capable. Select either Disabled, Super G without Turbo,
or Super G with Dynamic Turbo.
Disabled:
Super G
without
Turbo:
Capable of Packet Bursting, FastFrames, Compression,
and no Turbo mode.
Super
G with
Dynamic
Turbo:
Capable of Packet Bursting, FastFrames, Compression,
and Dynamic Turbo. This setting is backwards compatible
with non-Turbo (legacy) devices. Dynamic Turbo mode is
only enabled when all devices on the wireless network are
congured with Super G with Dynamic Turbo enabled.
Select On or Off.
Standard 802.11g support, no enhanced capabilities.
Wireless:
To Next Page
Loading...
