D-Link DWL-P200 - Connecting The DWL-P200; Base Unit Connections; Terminal Unit Connections

2
ENGLISH
Connecting The DWL-P200
Base Unit
Terminal Unit
P+DATA OUT:
provides the data and
power to the terminal
unit. Connect this port
to the P+DATA IN on
the Terminal unit.
LAN IN: connect an RJ-45
straight-through cable to
your computer or switch.
Power In: using the
supplied 48V power
supply, connect to a
wall power outlet.
P+DATA IN: connect
a CAT 5 RJ-45
straight-through
cable from the P +
Data Out port on the
Base Unit.
LAN OUT: connect a CAT
5 RJ-45 straight-through
cable to an Ethernet
enabled device.
Voltage Selector:
used to select DC
5V/2.5A or 12V/1A
DC Out: supplies 5V 2.5
or 12V 1 amps of power.
Using the included power
cable, connect to your
Ethernet enabled device’s
power.