D-Link DXS-3400 SERIES User Manual

- 1 -
HowTo Stack DXS-3400-Series
The DXS-3400-Series is a stackable switch.
The Stack can be built by 2 (single ring/chain) ports or 4 (double ring/chain) ports.
Be advised, that depending of which Stacking mode (2-port or 4-port) you choose the stacking ports will differ.
Example of Single Duplex Chain, showing different ports

D-Link DXS-3400 SERIES Specifications

General

Brand	D-Link
Model	DXS-3400 SERIES
Category	Network Router
Language	English

Summary

Stacking Configuration via CLI/Console

Initial Serial Port Settings

Configure baud rate, parity, and stop bits for console/CLI communication.

Accessing Configuration Mode

Log in and enter enable and configuration terminal modes for setup.

Defining Stacking Parameters

Set stacking mode (2/4-port), unit priority, and renumber units for proper stack formation.

Activating and Saving Settings

Enable stacking, exit config, save configuration, and reboot switches to apply changes.

Verifying Stack Status

Check stack stabilization and view status using the 'show stack' command.