11
Network Address Screen
The Network Address screen
asks for information that is
needed to connect a DVC-1000
call over the Internet. Most home
users with a cable or DSL
modem can leave the checkbox
checked to obtain an IP address
automatically.
If you know you cannot be as-
signed an IP address automati-
cally through a DHCP server
Using the Setup Wizard (continued)
then uncheck the checkbox and enter your IP address, Subnet mask and
Gateway.
Obtain an IP address automatically (Default)
The application will attempt to obtain the IP address from the DHCP server.
When this is checked, the other settings on this screen are automatically grayed.
Also, if this setting is checked, you will skip the DNS screen, described on the
next page, as the DNS will be set automatically.
IP address, Subnet mask, Gateway
If necessary, enter each of these settings for the DVC-1000. You will be able to
obtain the IP address, subnet mask and gateway address from your router
configuration settings, ISP or network administrator.
Host name (optional):
Your Internet Service provider may require you to provide a host name to connect
to the Internet. If this is required, you can enter it here. Today, this is rarely
required on a broadband connection and this setting is optional.
MAC: xx:xx:xx:xx:xx:xx
MAC (Media Access Control) is an unique identifier for the Ethernet network
hardware of your DVC-1000. If you need to know the MAC address of your
DVC-1000, it can be found on this screen.
Press Next to continue.
To Next Page
Loading...
Need help?
General
