D-Link VDSL2 User Manual

DSL-6540U
4
ENGLISH
TROUBLESHOOTING
SET-UP AND CONFIGURATION PROBLEMS
1. How do I configure my DSL-6540U router without the CD ?
- Connect your PC to the router using an Ethernet cable.
- Open a web browser and enter the address http://192.168.0.1
- The default username is ‘admin’. The default password is (leave the feld blank).
- If you have changed the password and can not remember it, you will need to reset the router to
set the password back to ‘’ (leave the eld blank).
2. How do I reset my router to factory default settings?
- Ensure the router is powered on.
- Press and hold the reset button on the rear of the device for 5-8 seconds.
Note: Resetting the router to factory default will erase the current conguration settings. To re-
congure your settings, log into the router as outlined in question 1, then run the Setup Wizard.
3. What can I do if my router is not working correctly?
- The manual contains a full troubleshooting section and can be downloaded from the D-Link
website (see below), however there are a few quick steps you can take to try and resolve any
issues:
- Check the LED’s on the front of the router.The Power LED should be on, and the DSL and LAN
LED should be on as well.
- Check that all the cables are rmly connected at both ends.
- Power the router off for 20 seconds, and then power it back on.
4. Why can I not get an Internet Connection?
- For ADSL ISP users, please contact your ISP to make sure the service has been enabled/
connected by your ISP and that your ISP username and password are correct.

D-Link VDSL2 Specifications

General

Brand	D-Link
Model	VDSL2
Category	Wireless Router
Language	English