EasyManua.ls Logo

d2itsu APD-9CRV2 - Trouble Shooting; Troubleshooting Tips

d2itsu APD-9CRV2
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
TROUBLE SHOOTING
TROUBLE SHOOTING TIPS
TROUBLES POSSIBLE CAUSES SUGGEST REMEDIES
1. Unit does not
Start when
Pressing on/off
Button
- P1 appears in the display window Drain the water in the bottom tray.
- Room temperature is lower than the
set temperature.(Cooling mode)
Reset the temperature.
2. Not cool enough - The windows or doors in the room
are not closed.
Make sure all the windows and
doors are closed.
- There are heat sources inside the
room.
Remove the heat sources if
possible.
- Exhaust air duct is not connected or
blocked.
Connect the duct and make
sure it can function properly.
- Temperature setting is too high. Decrease the set temperature.
- Air lter is blocked by dust. Clean the air lter.
4. Noisy or vibration - The ground is not level or not at
enough.
Place the unit on a at, level
ground if possible.
5. Gurgling sound - The sound comes from the owing
of the refrigerant inside the air-
conditioner.
It is normal.
6. Power shut off at
Heating mode
- The automatic over heat
protection function. When the
temperature at the air outlet
exceed 70ºC/158ºF,th e de vice will
stop.
Switch on again after the unit
has cool down.

Table of Contents