To Next PageTo Next Page
Need help?Do you have a question about the DAB EVOSTA2 OEM Series and is the answer not in the manual?
General| Protection Class | IP44 |
|---|---|
| Temperature Range | -10°C to +110°C |
| Max Operating Pressure | 10 bar |
| Insulation Class | F |
| Installation | Horizontal or Vertical |
| Application | Heating, Cooling |
| Motor Type | Permanent Magnet Synchronous Motor |
| Power Supply | 230V, 50/60Hz |
Ensures product integrity and safe handling during transport and storage.
Manufacturer's disclaimer for damage from tampering or unauthorized modifications.
Crucial warnings about electrical hazards, earthing requirements, and high voltage.
Guidelines for storing the circulator in a dry, protected environment to maintain condition.
Instructions for safe handling and transport to prevent physical damage to the unit.
Indicates that the packaging adhesive plate displays the total weight of the circulator.
Steps for physically mounting the circulator, including gasket use and shaft orientation.
Instructions for rotating the electronic control device for optimal IP protection and usability.
Ensuring minimum pressure is higher than the valve closing pressure when equipped.
Guidance on connecting the power supply to the pump unit, ensuring safety compliance.
Procedure for venting the pump before initial operation to remove any trapped air.
Differential pressure adjusts with water demand; Hs set point is adjustable.
Differential pressure remains constant regardless of water demand; Hs set point adjustable.
Circulator operates at a constant speed based on specific characteristic curves.
Identifies keys and luminous segments on the pump's control panel display.
Details the available pump operating modes with corresponding symbols and settings.
Specifies the default regulating mode pre-set by the manufacturer.
Details the PWM signal profile for the HEATING version, including working areas.
Safety precautions for cleaning and maintenance, emphasizing power disconnection.
Guidelines for environmentally friendly disposal of the product and its components.
