Need help?Do you have a question about the dacell AM-1000 and is the answer not in the manual?
Details the components and indicators on the front panel of the strain amplifier, numbered 1 through 18.
Describes the input/output connectors, fuse, and power components on the back panel, numbered 19 through 25.
Explains the function of each control, switch, volume, and display item on the amplifier, numbered 1 through 20.
Provides initial steps for powering the device and checking fuses or switches.
Details the connector type and pin assignments for connecting strain gauge sensors.
Guidelines for measuring high voltage signals and specific input conditions for accuracy.
Recommendations for selecting appropriate sensor cables for optimal performance and noise reduction.
Procedures to minimize noise and interference from external electrical devices during dynamic measurements.
Key considerations and procedures for accurate static strain measurements, focusing on cable resistance and temperature effects.
Details on connecting outputs to external devices and methods for controlling sensor voltage.
Instructions for performing bridge balance and adjusting the amplifier gain for precise measurements.
Guide to using the low-pass filter and its selectable cut-off frequencies for signal conditioning.
To Next Page
General