dacell AM-1000 - Page 9

8
It is the switch to control GAIN and it can be controlled as in X1, X10, X100,
X400, X1000 times.
○
12
GAIN control volume
It is a volume to control GAIN and it can be continuously controlled as in 을
from X1 up to X11 times.
○
13
GAIN fine control volume
It is a volume for the fine control of GAIN. It can be continuously controlled
as in from X1 up to X2 times.
○
14
Power lamp
This lamp shows you the power supply to Amplifier.
○
15
Power switch
This switch is to supply power to Amplifier.
○
16
Sensor input voltage monitor terminal
This can monitor Sensor input voltage
○
17
Sensor output voltage monitor terminal
This can monitor Sensor output voltage
○
18
Signal output monitor terminal
This can monitor output voltage of Amplifier.
○
19
Low-current output (more than 2kΩ load) connector
It is the final output signal of Amplifier and also low-current output.
You can use this more than 2kΩ load.
○
20
High-current output (more than 200 Ω load) connector
It is the final output signal of Amplifier and also high-current output.
You can use this on more than 200Ω load.
○
21
Sensor input connector (MS connector)
You can use Full bridge, Half bridge, Quarter bridge and Potentiometer
Voltage input ,etc
○
22
Case earth terminal
Connects and uses with outside ground in case of biographical environment
with noise is bad.
○
23
Fuse
It is a fuse to protect from outside excess current. AC 220V 0.5A)