HORN - ENGINE IMMOBILISER
82
ATT EN TIO N !
These operations must be performed only when the UCE anti starting is not in stand
by state.
The maximum number of electronic keys which can be re-programmed for a vehicle
is maximum 4; so, if the two original electronic keys of the vehicles have been lost or
have been defected, only maximum two other electronic keys may be re-programmed.
82 - 4
ELECTRONIC KEYS PROGRAMMING PROCEDURE
ELECTRONIC KEYS PROGRAMMING PROCEDURE
This is to be applied when the replacement of the electronic keys is needed and the procedure is
as follows:
- bring the switch (1) of the UCE anti starting in position “ON”;
- place the end of the first electronic key in contact with the anti starting receiver;
- after one second, place the end of the second electronic key in contact with the anti starting
receiver;
- bring the switch (1) of the anti starting UCE to the position “OFF“;
- check using both electronic keys the good operation of the anti starting.
To Next Page
Loading...
