EasyManuals Logo

Dacor Distinctive DR30D Planning Guide

Dacor Distinctive DR30D
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
DR30D, DR30DH, DR30DI, DR30DIH
Distinctive
30” Wide
Dual Fuel Range
Document # PG05-006
Revised 06/13/13 Page 1/7
Optional Backguard and Island Trim Part Numbers
Description Part Number
Island trim kit (no backguard) ADTK30D
6 inch trim kit ADB3006
9 inch trim kit ADB3009
NOTE: Model DR30D[H] is NOT designed for self-rimming
installation or installation with a raised vent.
NOTES:
When installing model DR30DI[H] with a raised vent, install
only Dacor model ERV3015.
The backguards shown above for model DR30D[H] are NOT
compatible with model DR30DI[H].
This model can be installed in a freestanding configuration
between cabinets, provided the countertop is as high at the
trim around the cooktop.
* Standard
** Optional
1 1/8” (2.9 cm)
35 3/4
(90.8 cm)
to
37 7/8
(96.2 cm)
Rear of control panel/oven door
Control panel
Front of knobs
Front of handle
Full size side panel
Front of open door
Width at front panel:
29 7/8 (75.9 cm)
1 1/8” (2.9 cm) to cooking
surface (top of grates) from
top of trim
46 3/8 (117.8 cm)
28 1/2 (72.4 cm)
28 7/8 (73.3 cm)
26 1/2 (67.3 cm)
24 3/8 (61.9 cm)
9” (22.9 cm)
Backguard**
6” (15.2 cm)
Backguard**
3” (7.7 cm)
Backguard*
External handle
shown, some models
have integral handle
(see inside cover)
1” (2.5 cm)
35 7/16
(90.0 cm)
to
37 9/16
(95.4 cm)
Rear of control panel/oven door
Rear trim overhang
Control panel
Front of knobs
Front of open door
Width at front panel:
29 7/8 (75.9 cm)
1 7/16 (3.7 cm) to cooking
surface (top of grates) from
bottom of trim
5/16 (8 mm)
Trim thickness
3 1/4” (8.3 cm)
Removable
side panel
46 3/16 (117.3 cm)
28 5/16 (71.9 cm)
26 5/16 (66.8 cm)
24 3/16 (61.4 cm)
Front of handle
28 11/16 (72.9 cm)
External handle
shown, some models
have integral handle
(see inside cover)
Product tolerances: ±1/16” (±1.6 mm) unless otherwise stated.
WARNING
• Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
• This appliance must be installed in accordance with
the accompanying installation instructions.
PRODUCT DIMENSIONS - MODEL DR30D[H] (FREESTANDING MODEL)
PRODUCT DIMENSIONS - MODEL DR30DI[H] (SELF-RIMMING MODEL)

Other manuals for Dacor Distinctive DR30D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dacor Distinctive DR30D and is the answer not in the manual?

Dacor Distinctive DR30D Specifications

General IconGeneral
BrandDacor
ModelDistinctive DR30D
CategoryRanges
LanguageEnglish

Related product manuals