Grill Placement and Use
Page 3
Instructions for Use
STEP 1 Make sure all burners are off and the cooktop/range is cool to the touch. Put the
grill over the top of the grate on the side of the appliance with the knobs that have
the MAX GRIDDLE icons. The grease trap goes toward the back. Fit the tabs that
stick out of the bottom of the feet into the inside corners of the grate. When correctly
installed, the grill will rest securely about 1/2” above the top surface of the grate. It
may rock back and forth slightly, which is normal.
STEP 2 Set one of the burners under the grill to the light (high) position.
Once lit, immediately turn the knob to the MAX GRIDDLE position,
or lower if desired. DO NOT keep the burner knobs higher than the
MAX GRIDDLE setting after they are lit!
STEP 3 Repeat step 2 for the other burner under the grill.
STEP 4 During cooking be careful with metal utensils on the surface
because they can scratch the non-stick coating. See below for cleaning instructions.
After each use, wash the grill thoroughly in hot soapy water to avoid stains from grease build-up. The grill is coated
with a non-stick coating for easy cleaning. Warm water and liquid detergent are all that are needed for cleaning.
Remove stubborn spots with a non-abrasive plastic mesh pad. To prevent scratching, do not use abrasives or
abrasive cleaners.
Cleaning the Grill
Line up bottom
of grill with top
of grate
ER36G and ER36GI Range DRT366S Cooktop
Grease trap
toward back
or
Put over left or right burners
(not center burners)
Grease trap toward back
Put over left or right burners
(not center burners)
or
Line up bottom
of grill with top
of grate
Light position
To Next Page
Loading...
Need help?
General