10
Ground
Power
Input
Blower
Output
Installation Instructions
Electrical Access
Panel
ERV Electrical
Access Panel
ERV Raised Vent
Front View
To power conduit
Connect other end of
wires to remote blower
terminal block
Wires to power plug
Pre-wired at factory
Do not modify
Attach ground wire
as shown
Match wire colors to
terminals as shown
BLACK
WHITE
GREEN
Electrical Installation
WARNING
ELECTRIC SHOCK HAZARD - Do not connect power to
the unit until installation is complete.
Run the conduit line used to supply power from the 1.
raised vent to the remote blower parallel to the duct
work.
Make sure the raised vent power plug is disconnected 2.
from the electrical outlet.
Remove the cover from the raised vent electrical 3.
access panel.
Connect the conduit to the remote blower as shown in 4.
the wiring diagrams on this page and the facing page.
Replace the electrical access panel.5.
To Next Page
Loading...
