Dacor Integrated IF36BNDFSF - Replacing Light Bulbs; Freezer Section

14
15
Ca r e a n d Cl e a n i n g
re p l a C i n g li g h t bU l b s
WARNING
To avoid electrical shock which can cause severe personal
injury or death, disconnect power to refrigerator before replacing
light bulb. After replacing light bulb, reconnect power.
CAUTION
To avoid personal injury or property damage, observe the
following:
Allow light bulb to cool.•
Wear gloves when replacing light bulb.•
fr e s h fo o d se C t i o n
1. Slide clear light shield toward back of compartment to release
from light assembly.
2. Remove light bulbs.
3. Replace with appliance bulbs no greater than 40 watts.
4. Replacelightbulbcoverbyinsertingtabsonlightshieldinto
liner holes on each side of light assembly. Slide shield toward
front of refrigerator until it locks into place. Do not force shield
beyond locking point. Doing so may damage light shield.
fr e e z e r se C t i o n
1. Reach behind the light cover.
2. With firm pressure, press
forward on the notches at the
back of the cover and pull
down. The cover will open
from the back.
3. Remove the cover.
4. Removelightbulb.
5. Replace bulb with appliance
bulb no greater than 40
watts.
6. Insert front tabs of light cover
into slots in freezer liner
and snap rear portion over
light assembly until rear tab
engages.