NS4710 / NS6010 / NS4710H / NS5310H / NS6010H
4
-
10
Switch
position
Turning Lamp
2WD Normal turning Lamp OFF
4WD Normal turning
4WD
Lamp ON
The 4WD function can be used un-
der the following conditions:
1. If high traction is needed in a hu-
mid area.
2. When towing a trailer or using a
loader.
3. When working on a sandy surface.
4. When the tractor is pushed out by
reaction from the implement during
cultivating on a hard surface.
5.When cultivating aeld or driving
over a bank.
To avoid accident:
•
Engage the switch only when
the vehicle is stationary.
•
While the 4WD is engaged,
drive the vehicle with low
speed as steering and braking
characteristics may differ.
•
It is possible to engage the
4WD during driving. However,
you may hear noise or feel
slight shift impact some at
times in this case. For safe
driving, engage the 4WD when
the tractor is stationary.
•
The 4WD should not be used
on a paved road as tires can
be worn faster.
CAUTION
1. The tractor has a 540rpm speed
position.
2. Electric/Hydraulic engagement
PTO shifting needs clutch opera-
tion. Press the clutch pedal down
completely to stop the tractor
movement and any PTO driven
equipment movement before shift-
ing the PTO gear shift lever.
(1) Auto-Manual Switch (2) PTO Switch
PTO SETTING SWITCH
te7O433a
REAR PTO SWITCH
te170 (NS4710, NS6010, NS4710H, NS5310H, NS6010H)-���-04.indd 10 2021-03-15 �� 1:54:04
To Next Page
Loading...
