5
Removing transit bolts
1. Before operating the washer, remove the
transit bolts(x3) along with the rubber around
them.
• If the bolts are not removed, it may cause
excess noise, vibration or malfunction.
2. Unscrew the 3 bolts with a 10mm hex
wrench or spanner or cross-tip screwdriver.
Do not discard the bolts.
• When the appliance is transported, the
transit bolts will need to be re-used.
3. Close the holes with the cap holders supplied.
Location of washer
• Check the location where the washer will be installed. Make sure you have everything
necessary for correct installation.
• Do not place or store your washer below 0°C (32°F) to avoid any damage from freezing.
• Do not place or store laundry products on top of washer at any times.
• Install the washer on the horizontal, solid, level floor.
If the washer is installed on an unsuitable floor, it could make
considerable noise, vibrate severely and cause a malfunction. If the
washer is not level, adjust leg up or down for horizontal installation.
• Ventilation openings must not be obstructed by carpeting when the
washer is installed on a carpeted floor.
•
Leave some space around the machine (right & left : 2cm, rear : 10cm).
• In case of built-in installation, the distance between top of the washer
and bottom of upper plate should be at least 3mm.
INSTALLATION INSTRUCTIONS
Drain Hose
Washer
Laundry
Tub
approx.
2cm
To Next Page
Loading...
