5) Wiring harness
(1) The wiring harness layout is as shown below.
- 125 -
EA2M4012
(2) Position each switch on the check-
er(407980-2090) as shown at left.
COUTION : Leave the power
switch OFF to pre-
vent the pre-stroke
actuator from over-
heating.
EA2M4013
(3) Reinstall the measuring device
(105782 -4371) on the No.1 cylinder
as described in ‘Injection timing
adjustment’.
(4) Adjust the pump test stand’s fuel oil
supply pressure to as low a pressure
as possible (eg. 20 kPa(0.2 kgf/cm
2
)).
(5) Turn the pump test stand’s flywheel
and adjust the No.1 cylinder’s lift to
4
L
0.05mm (refer to pages 50 and
51).
EA2M4014
To Next Page
Loading...
