Daewoo DE12 - Page 49

3.1.37. Piston and connection rod
1) Disassemble the pistons by two hands
while turning the crankshaft.
2) Unscrew the conn. rod fixing bolts and
take off the pistons and conn. rods in
the direction of piston.
- 46 -
EQM3035I
3) Remove the piston pin snap rings, take
off the piston pin, then disconnect the
conn. rod from the piston.
EQM3036S
4) Disassemble the piston rings using ring
pliers.
5) Take care not to interchange the disas-
sembled parts and keep them in the
sequence of cylinder No.
EQM3037S
3.1.38. Cylinder liner
1) Take off the cylinder liner.
EQM3038I
Piston ring jig