7
operating the appliance in wet grass, where feasible. Always be sure of
your footing on slopes. Walk, never run. Always work across the face of
slopes, never up and down.
Exercise extreme caution when reversing or pulling the appliance
towards to you.
Do not operate the appliance on excessively steep slopes.
Use extreme caution when reversing or pulling appliance towards you.
Stop the rotating parts if appliance has to be tilted for transportation.
Do not operate the cutting means when crossing surfaces other than
grass, and when transporting the appliance to and from the working
area.
Never operate the appliance with defective guards or shields, or wi-
thout safety devices, for example deectors and/or catchers in place.
Switch on the motor according to instructions and with feet well away
from rotating parts.
Do not tilt appliance when switching on the motor, expect if the applian-
ce has to be tilted for starting. In this case, do not tilt it more than abso-
lutely necessary and lift only the part, which is away from the operator.
Always ensure that both hands are in the operating position before
returning the appliance to the ground. Do not put hands or feet near or
under rotating parts.
Never pick up or carry an appliance while the motor is running.
Pull the plug from the socket:
• Whenever you leave the machine.
• Before clearing a blockage.
• After striking a foreign object. Inspect the appliance for damage
and make repairs as necessary.
• If the appliance starts to vibrate abnormally, check immediately.
When the machine is at work in the thick bushes or runs into obstacles
it can’t cut down, the blade will be stalled so that the machine tempe-
rature and current will increase. When the temperature is too high or
the current is too large, the overload protection device installed inside
the machine will automatically shut off the power to stop the machine (
To Next Page
Loading...
