12
ELECTRIC AL REQ U IREMEN TS
ELECTRICAL GROUNDING INSTRUCTIONS
WARNING :
Do not remove, modify or immerse this plug. If this device trips, the cause is to be corrected before
further use, see owners manual.
This device must only be plugged on appropriate wall outlet.
Do not use on extension cords.
USAGE OF POWER CORD(AFCI OR LCDI)
Testing:
CASE 1 : Lamp exists
1. Plug into power receptacle.
2. If light is not on, press "RESET" button, light should turn on.
3. Press "TEST" button, light must turn off.
4. Press "RESET" button again for use. Light should turn on.
Do not use of above test fails.
CASE 2 : Lamp not exist
1. Plug into power receptacle. Turn on Unit.
2a. If unit operates normally, press "TEST" button. Unit should trip.
Press "RESET" button again for use.
2b. If unit not operate, press "RESET" button for use. Unit should operate.
Do not use if above test fails.
Because of potential safety hazards under a certain condition , we strongly recommend against the use of an
extension cord . However , if you still elect to use an extension cord, it is absolutely necessary that it will be a
UL Listed 3-wire qrounding type appliance extension cord having a 3-blade grounding piug and a 3-slot
receptacle that will plug into the appliance.
The marked rating of the extension cord should be 115V, 15A or equivalent.
WARNING :
To avoid death, personal injury or properly damage due to electrical shock,
Do not use anextension cord or pinch the power cord.
Do not remove the wanning tag from the power cord or equivalent.
●
●
To Next Page
Loading...
Need help?
General
