THE REPAIR METHOD
20
No. Process Notice
Assemble 2
5
6
7
8
Assemble the fastening nut
Assemble the Belt
Assemble the protector
Final checking
- Use fixing jig and 17mm
socket wrench as if
disassembling, as fastening
torque about 100~200kgf-cm.
- Check the end-play, up and
downward and check the
binding force, too much or
not on bi-direct of rotation.
Finally, check the distance
between brake lever and
control bolt(2~3mm).
Also, check the interferance
depth both clutch tip and clutch
boss(3.5~4.5mm).
Clutch Tip
Drain
Valve
Synchronous
Motor
3.5~4.5
keep distance
2~3mm
To Next Page
Loading...
