Caution!
The dryer must be connected to the cold water faucet using the new inlet hose.
Do not use old hoses
Do not overtighten, as it may damage the coupling.
16
STEP10. Connecting the inlet water hose for steam features
1. Before installing dryer turn the cold water faucet off.
2. Attach the brass female end of the “Y” connector to the
cold water wahser fi ll valve.
3. Connect the hose to cold waher faucet and “Y”
connector
4. Connect straight end of hose which supplied with dryer
accessory package to other end of “Y” connector
5. Connect angled end of hoses to fi ll the valve at the top
of the dryer’s rear frame.
6. Using pliers, tighten all the coupling with an additional
2/3 turn after hand tightening.
7. Turn the water faucets on.
8. Check for leaks around “Y” connector, faucets and
hoses.
To Next Page
Loading...
Need help?
General
