17
Stacking Kit Installation Instructions(DRYER & PEDESTAL)
To ensure safe and secure installation, please observe the instructions below.
1) Remove pedestal, installation hardware, and instructions are in the shipping carton.
2) Position dryer on top of the pedestal.
A : Uninstalling an electric dryer:
1 Unplug the power supply cord,
2 Pull the dryer away from the wall enough to loosen
the vent clamp.
Loosen the clamp and carefully remove the exhaust
vent from the dryer exhaust outlet.
B : Uninstalling a gas dryer:
1 Shut off gas.
2 Unplug power cord.
3 Disconnect gas line from dryer.
4 Pull away and loosen vent clamp.
5 Disconnect venting.
PART 3 ACCESSORIES INSTALLATION
WARNING!
Incorrect Installation can cause serious accidents.
The weight of the dryer and the height of installation makes the stacking procedure too risky for one person.
This procedure should be performed by 2 or more experienced service personnel.
NOTE:
Because of the weight of the dryer two or more people may be needed.
If dryer was previously installed, uninstall it as follows
Refer to pedestal installation manual.(Pedestal Model : P-W151)
To Next Page
Loading...
Need help?
General
