2. Bracket Geared Motor Assembly (Dispenser Models Only)
1) Disassembling Procedure
2) How to check the Hose Ice Maker Tube As.
HOW TO CHECK EACH PART
No No
Check solenoid Valve and Motor.Separate 6 pin connector of Geared Motor.
36
Unscrew 6 points.
Remove 2 screws. Pull the Bracket Geared Motor.
25
And unscrew 4 points.
14
Procedure Procedure
( Good ): 11.3 Ohm (+-10%)
(10.8 ~ 12.7 Ohm)
(Defective): Change the part.
( Good ): 145 Ohm (+-8%)
(133 ~ 156 Ohm)
(Defective): Change the part.
Parts How to Check Remark
Checkthe resistance of
2 terminals with a Tester.
Checkthe resistance of
2 terminals with a Tester.
Cube Soloneid Valve
Geared Motor
33
To Next Page
Loading...
