SERVICE AND MAINTENANCE 7–27
CAUTION
Greasy fingers will cause stains, re-
sulting in a dull light.
• Do not touch halogen bulbs with
bare hands.
• Clean with a clean non fluffy cloth
using alcohol or white spirits.
HEADLAMP HIGH AND LOW BEAM
1. Open the engine hood and engage the
support.
2. Rotate the plastic cap counterclockwise
and remove.
3. Disconnect the wiring harness connec-
tor from rear of the bulb.
4. Release the bulb retaining spring and re-
move the bulb.
5. Replace the bulb with a new one.
6. Install in the reverse order of removal.
When installing new bulb, ensure that the
lugs on the bulb holder engage correctly
in recesses of the housing.
7. Rotate the plastic cap clockwise.
POSITION LAMP
1. Open the engine hood and engage the
support.
2. Rotate the plastic cap counterclockwise
and remove.
3. Pull out the bulb holder located next to
the head lamp bulb.
4. Remove the bulb by pulling straight out
of the bulb holder.
5. Replace the bulb with a new one.
6. Install in the reverse order of removal.
To Next Page
Loading...
