AUDIO SYSTEM* (RADIO, CASSETTE AND CD PLAYER) 5–19
GENERAL OPERATION
Power / Volume Control Knob
Power On:
Turn ignition switch to ACC or ON.
Press the power/volume control knob to
activate the audio system.
The radio frequency, tape or CD changer
signal will appear on the VFD.
Power Off:
Press the knob again to turn the audio sys-
tem off.
All signals will disappear from the VFD.
How to Adjust the Sound
Sound Mode Selection:
To select the desired audio mode, press
sound mode selector button.
The audio mode indicator and numeric sig-
nal will appear.
Each time you press this knob, the audio
mode changes as follows in order:
→ VOL → BAS → TRE → FAD→ BAL
When the desired mode is selected, adjust
the sound by rotating power/volume control
knob.
After adjusting, the display will return to full
audio system information in 5 seconds.
Volume Control (1) :
1. Rotate power/volume control knob clock-
wise to increase the volume and coun-
terclockwise to decrease volume. The
volume level will appear as a numeric
signal.
2. After adjusting, the display will return to
full audio system information in 5 sec-
onds.
NOTE
• Upon activation, the audio system
will start up in the mode it was in
when last on.
• When ejecting a tape, mode is au-
tomatically transferred to the ra-
dio.
• Audio system can be operated
when the ignition key is at "ACC"
or "ON" position.
To Next Page
Loading...
