7. Pour out the hot water in the cup(s) from the pre-heating and place your
warmed cups on the Drip Tray Plate (11).
8. Ensure that the Steam Control (6) is set to the ‘OFF’ position.
9. Insert the mains plug into the nearest socket.
10. Press the Power Button (2), the power button will flash whilst the unit is
warming up.
11. Once the button has stopped flashing, the Power Button (2) and the Brewing
Button (4) will both illuminate to show the espresso maker has warmed up.
12. Press the Brewing Button (4) which will start the brewing process and hot
coffee will be dispensed into the cup(s). Be careful not to overfill the cup(s).
NB the Brewing Button (4) will flash whilst the coffee is being dispensed.
13. Press the Brewing Button (4) to stop brewing once the cup is full.
WARNING! Do not leave the Espresso Maker unattended whilst the coffee is
being dispensed as the Brewing Button (4) must be pressed to stop the unit
dispensing coffee.
14. Remove the Coffee Filter Holder (14) and the Coffee Filter (15) once cool and
rinse clean in running water.
To Next Page
Loading...