Espresso Maker
Model No. SDA2698
User Manual
IMPORTANT – RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Non-Rewireable Mains Plug
If your appliance is supplied with a non-rewireable plug fitted to the mains lead
and should the fuse need replacing, you must use an ASTA approved one
(conforming to BS 1362 of the same rating). If in doubt, consult a qualified
electrician. Never use a plug with the fuse cover missing.
If you need to remove the plug – DISCONNECT FROM THE MAINS – and then cut
it off the mains lead and immediately dispose of it safely. Never attempt to reuse
the plug or insert it into a socket outlet as there is a danger of electric shock.
Troubleshooting Guide
No water in the water
tank
Fill the tank with water, run
through the appliance without a
coffee filter to ensure it is fully
primed
The coffee grounds are
too fine or tamped down
too hard
Empty the filter and rinse under
water to clean, Wipe the filter with
a cloth.
Refill the filter with grinds and
tamp
No steam from the Steam
wand
Steam Nozzle tube is
blocked
See page 15, “If the steam outlet
becomes blocked”
No water in the water
tank
Fill the tank with water, run hot
water through the Steam Nozzle to
ensure water flows
Water is leaking from the
bottom of the machine
Too much water in the
drip tray
Water is leaking from the
outer side of the filter
There is some ground
coffee on edge of filter
Tainted taste to the coffee
Allowing water to sit too
long, improper cleaning
Low or no steam from the
steam wand
Steam Nozzle is clogged
up
To Next Page
Loading...