3
ZF 8/16S-151/181 AND 16S-221 GEARBOXES
Removal and installation of gearbox CF65/75/85 series
4-6
4.3 REMOVAL AND INSTALLATION, OUTPUT SHAFT OIL SEAL
Removing the output shaft oil seal
1. Remove the prop shaft from the gearbox
flange and hang it on the chassis.
2. Remove the prop shaft flange.
3. Drill two holes into the external cover of the
oil seal and turn the special tool
(DAF No. 0484899) into the oil seal. Then
pull the oil seal out of the bearing cover
using the special tool (DAF No. 0694928).
Installing the output shaft oil seal
1. Apply a small amount of liquid gasket to the
outside of oil seals fitted with a steel cover.
Apply green soap sparingly to the outside of
oil seals fitted with a rubber cover.
2. Pull the oil seal into the bearing cover using
the special tool (DAF No. 0694780).
3. Fit the prop shaft flange.
4. Attach the prop shaft.
W 3 03 085
7
ᓻ 200337
https://www.truck-manuals.net/
To Next Page
Loading...
