DAF CF75 Series - Page 245

3
CF65/75/85 series Removal and installation of gearbox
ZF 8/16S-151/181 AND 16S-221 GEARBOXES
4-7
4.4 REMOVAL AND INSTALLATION, GEARBOX FRONT COVER OIL SEAL
Removing the gearbox front cover oil seal
1. Remove the gearbox.
2. Remove the clutch lever from the clutch
housing.
3. Remove the attachment nuts from the
gearbox front cover and remove the
gearbox front cover.
4. Remove the oil seal from the gearbox front
cover.
5. Remove the old gasket from the gearbox
front cover and/or from the gearbox
housing.
V300441
Installing the gearbox front cover oil seal
1. Apply a thin layer of liquid gasket to the
outer circumference of the oil seal and
install the oil seal in the gearbox front cover
using the special tool (DAF No. 0535703).
2. Check the input shaft bearing axial play.
See “Inspection and adjustment”.
3. Slide the gearbox front cover over the
input shaft and tighten the gearbox front
cover to the specified torque. See
“Technical data”.
4. Install the clutch lever in the clutch housing.
5. Fit the gearbox.
V300128
7
ᓻ 200337
https://www.truck-manuals.net/