3
CF65/75/85 series Removal and installation
PTO
4-13
4.11 REMOVAL AND INSTALLATION, PTO INTERMEDIATE SHAFT ON
GEARBOX WITHOUT INTARDER
Removing intermediate shaft without
intarder
1. Drain as much gearbox oil as necessary
and collect it in a clean container.
2. Remove the PTO.
3. Remove the centring sleeve.
4. Remove the intermediate shaft with bearing
and circlip from the rear cover of the
gearbox.
5. Remove the circlip and the intermediate
shaft bearing, if necessary.
Installing intermediate shaft without intarder
1. Note:
The intermediate shaft can be installed
without any measurements being taken.
Install the bearing and the circlip on the
intermediate shaft.
2. Install the intermediate shaft in the rear
cover of the gearbox.
3. Install the centring sleeve on the rear cover
of the gearbox.
4. Install the PTO.
5. Check the oil level in the gearbox.
13
ᓻ 200337
https://www.truck-manuals.net/
To Next Page
Loading...
