1
1 Installation Preparation
1.1 Basic Requirements
● All installation and operations shall conform to your local electrical safety regulations, fire
protection regulations, and other relevant regulations.
● Make sure that the application scenario conforms to installation requirements. Contact your
local retailer or customer service center if there is any problem.
● Use the Device according to the operating environment.
● Keep the original packing material well because you might need it to pack the Device and
send it back for repair.
1.2 Installation Check
● Make sure that the place where the Device is installed has enough space to hold the
Device and its mounting accessories.
● For PTZ cameras, make sure that the place where the Device is installed can sustain at
least 4 times the weight of the Device and its mounting accessories; for speed domes,
make sure that the ceiling and wall can sustain 8 times the weight of the Device and its
mounting accessories.
● Do not install the Device at risky or unstable places.
● Make sure that the wall is thick enough to install expansion bolts (Users need to buy
expansion bolts separately).
● For speed domes support intelligent tracking, illegal parking capture or laser, make sure
that the mounting height is over 6 m.
1.3 Cable Preparation
Select the video cable depending on transmission distance.
1.3.1 Video Cable Requirements
● 75 ohm.
● Pure copper cored cables.
● 95% braided copper shielding.
● For cables applicable to network devices and their maximum transmission distance, see
Table 1-1.
● For cables applicable to HDCVI devices and their maximum transmission distance, see
Table 1-2.
To Next Page
Loading...
Need help?
General
