User’s Manual
258
On the humidity information line, click .
Setting
Configure the settings for the following parameters.
Table 5-43 Alarm settings
Access Point Indicates the channel that the camera is connected to.
Type
by default.
Detect Position Name Set the detect position name.
Preview Channel
Select the channel that you want to preview to help monitor the channel
of access point. This channel could be the channel of access point or any
other channels according to your actual situation.
Event Type
Select event type as
or
, and set the upper
and low humidity limit respectively. For example, select event type as
and set upper limit as
, the alarm occurs when the
humidity reaches 60%RH.
Upper Limit
Enable Enable the alarm function.
Schedule
Define a period during which the alarm setting is active. For more
information about setting the period, see "5.10.4.1 Configuring Motion
Detection Settings."
Alarm-out Port
Click
to display setting page.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm a
ctivation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices connected
by USB gateway or camera gateway.
To Next Page
Loading...
Need help?
General
