User's Manual
205
Click Apply to complete the settings.
After the Device is connected to a Wi-Fi hotspot, in the Wi-Fi Working Info area, the current
hotspot, IP address, subnet mask, and default gateway are displayed.
5.14.1.4 Configuring PPPoE Settings
PPPoE is another way for the Device to access the network. You can establish network connection by
configuring PPPoE settings to give the Device a dynamic IP address in the WAN. To use this function,
firstly you need to obtain the user name and password from the Internet Service Provider.
Select Main Menu > NETWORK > PPPoE.
PPPoE
Enable the PPPoE function.
In the User Name box and Password box, enter the user name and password accordingly
provided by the Internet Service Provider.
Click Apply to complete the settings.
The system pops up a message to indicate the successfully saved. The IP address appears on
the PPPoE interface. You can use this IP address to access the Device.
When the PPPoE function is enabled, the IP address on the TCP/IP interface cannot be
modified.
To Next Page
Loading...
Need help?
General
