Add users to the new group.
1. Press [User].
2. Press in the pop-up interface.
3. Press to enter user ID.
Repeat Step 2~ Step 3 and continue to add users. Max. 50 users can
be added.
4. Press , and press [Yes] to save according to interface prompt.
Select unlock mode, including card, fingerprint, password and face.
1. Press [Unlock Mode] to select the mode.
2. Press , and press [Yes] to save according to interface prompt.
The door can be unlocked after valid users unlock.
Valid user cannot be greater than total number of user.
When valid user equals to total number of user, the door can be
unlocked after all members of the group unlock.
When valid user is less than total number of user, the door can be
unlocked after any members of the group reach valid user.
Table 3-2
Press . The screen prompts “Do you want to save settings?” 步骤3
Press [Yes] to complete group combination config. 步骤4
3.6.3 Alarm
Enable or disable alarm, including intrusion, anti-passback, duress, door sensor timeout and
door sensor on.
To Next Page
Loading...
