Dahua ASA4214F - Page 36

27
Select “Access > Alarm”, and the screen displays Figure 3-21. 步骤1
Figure 3-21
Set the alarm according to needs. Please refer to Table 3-3 for details. 步骤2
 : enable.
 : disable.
Parameter
Note
Intrusion
Intrusion alarm will be triggered if the door sensor is opened when the
door is not opened normally.
Anti-passback
After enabling anti-passback function, an alarm will be triggered if a
person is verified to enter, leaves without verification and then requests
entry verification again.
Duress
Duress alarm will be triggered if the user enters with duress card, duress
password or duress fingerprint.
Door Sensor
Timeout
Timeout alarm will be triggered if opening time exceeds “Door Sensor
Timeout”. Press “Door Sensor Timeout”, enter timeout (1s～9999s) and
press to save.
Door Sensor
On
Enable door sensor. Intrusion and door sensor timeout alarm will be valid
only after door sensor is enabled.
Table 3-3
3.6.4 Door Status
Door can be set to be normal, NO or NC.
Select “Access > Door Status”, and the screen displays Figure 3-22. 步骤1