Dahua ASA4214F - System Operation: System Settings

34
Enter “Verification Interval Time” (unit: minute). In case of continuous card swiping 步骤2
during the set time, record the first card swiping time only.
Press to complete config. 步骤3
3.8 System
3.8.1 Time
Set system date, time format, DST (Daylight Saving Time) and NTP check.
Select “System > Time”, and the screen displays Figure 3-31. 步骤1
Figure 3-31
Configure parameters by reference to Table 3-5. Then, press to save config. 步骤2
Parameter
Note
24-hour System
After it is enabled, the time is displayed in 24-hour system. Otherwise,
the time is displayed in 12-hour system.
Date Setting
1. Press [Date Setting].
2. Enter year, month and date.
3. Press to save.
Time
1. Press [Time].
2. Enter the time.
3. Press to save.
Date Format
1. Press [Date Format].
2. Press textbox in the pop-up interface; select date format,
including DD-MM-YY, YY-MM-DD and MM-DD-YY.
3. Press to save.