1. Press [DST Setting].
2. Press the switch and it is enabled when it displays .
3. Press [DST Type] to select weekly or monthly.
4. Press [Start Time] and “End Time” to set the time.
Set NTP check function.
1. Press [NTP Check].
2. Set parameters.
Server IP address: fill in IP address of NTP check server.
The device will check time according to the server.
Port: fill in port number of NTP check server.
Interval (min): time interval of NTP check.
3. Press the switch and it is enabled when it displays .
4. Press to save.
Table 3-5
3.8.2 Face Parameter
It is suggested that this parameter should be used by professionals during debugging, and
should not be adjusted by users.
According to actual situation, adjust camera parameters and ensure picture definition.
Select “System > Face Parameter”, and the screen displays Figure 3-32.
For indoor use, it is suggested that exposure should be adjusted to manual mode and exposure
time should be 1/4000, in order to obtain better face recognition experience. Specific setting
method: Exposure (select the 5
th
, and press OK) Exposure Mode (press Left key) Manual
(press OK) Shutter (press Left key) 1/4000.
Figure 3-32
To Next Page
Loading...
