Dahua ASA4214F - Page 48

39
 IP Address
Select “IP Address”, and the screen displays Figure 3-38. 1.
Figure 3-38
According to actual situation, configure parameters by reference to Table 3-6. 2.
Parameter
Note
IP Address, Subnet
Mask and Gateway
IP Address
Set device IP address, subnet mask and gateway, ensure that IP
address and gateway are in the same network segment, and press to
save.
Enable/Disable
DHCP
DHCP: Dynamic Host Configuration Protocol.
Enable DHCP function and obtain IP address automatically. Then, “IP
Address”, “Subnet Mask” and “Gateway IP Address” cannot be set.
Enable/Disable P2P
During use, it is unnecessary to apply for dynamic domain name,
carry out port mapping or deploy transit server, so as to manage the
device easily and conveniently.
Table 3-6
Press to save the setting. 3.
 Active registration is a reserved function.
3.9.2 Serial Port
Select input/output mode according to purpose of the connected device.
Select “Connection > Serial Port”.
 Select “Serial Input” when connecting other card readers.
 Select “Serial Output” when connecting a third-party device or custom-made device.
3.9.3 Wiegand
Select input/output mode according to purpose of the connected device.
Select “Connection > Serial Port”.
 Select “Wiegand Input (Connect Reader)” when connecting other readers.