Dahua HD IR Vandal Proof Network Dome Camera Quick Start Guide
Note:
When you need to reset the device, press the “Reset” button in Figure 2-2 for 10 seconds while
connecting device to power.
When you need to use WPS function, press the “Reset” button in Figure 2-2 for 1 to 2 seconds while
connecting device to power, then press WPS button on the router. Generally the device can be
connected to corresponding router within 1 minute (supported by some series products).
Step 6
Take dome enclosure, put it back on the camera properly regarding to screw and hole, and fasten the
three inner hex screws with wrench.
2.2 Micro SD Card Installation
Note:
Some series products do not support the Micro SD card storage function. Please shut down the power
and then turn off the device before you install the Micro SD card.
Step 1 Find the Micro SD Card slot in figure 2-2, open the Micro SD Card slot according to the
direction in figure 2-3.
Step 2 Adjust the Micro SD Card to proper direction and install it in the Micro SD card slot.
Step 3 According to the direction in figure 2-4, close the Micro SD card slot and keep it locked.
Figure 2-3 Micro SD Card installation illustration 1
Figure 2-4 Micro SD Card installation illustration 2
To Next Page
Loading...
Need help?
General
