Alarm Control Panel Installer Manual
28
Installation 1.18
Keypad installation Figure 1-14
Loosen the screws on the back of Keypad to remove the rear panel. Step 1
Pull the cables out of the rear panel.
Step 2
Drill a hole on the wall①, and put the expansion bolt② through the rear panel to fix it onto the wall. Step 3
Put the self-tapping screws④ into the other installation holes on the rear panel③ and then fasten Step 4
screws.
Connect the cables to the ports on the main board. Step 5
Align the clamps on the top of main board with the ones on the rear panel⑤, and then slowly attach Step 6
the main board to the rear panel. The installation is completed⑥.
To Next Page
Loading...
