Alarm Control Panel Installer Manual
29
5 Installer Menu
This Chapter describes the menu operations included in the Installer Menu.
Entering the Installer Menu 1.19
To enter the Installer Menu, the TECHNICIAN must be authorized from the User Menu.
The default TECHNICIAN code for entering the Installer Menu is 1961.
Type in the access code (Default Supervisor code1234), and then press . Step 1
The ZONE TROUBLES menu is shown on the LCD display. See Figure 1-15.
Zone troubles Figure 1-15
Press and to scroll up and down until you reach the TEHCNICIAN menu. See Figure Step 2
1-16.
Technician Figure 1-16
Press . Step 3
Three beeps confirm the TECHNICIAN code operational and authorized for a defined period.
Press to exit from the TECHNICIAN menu. Step 4
A message shows "EXIT FROM MENU" is shown.
Press to return to the main interface. Step 5
Type in TECHNICIAN code (Default 1961) and then press to enter the Installer Menu.
Step 6
The KEYPADS menu is shown. See Figure 1-17.
Keypads Figure 1-17
Installer Menu Options 1.20
The Installer Menu consists of many submenus for management and programming operations as below:
To Next Page
Loading...
