Dahua DHI-ARC3008C - Module Functions

Alarm Control Panel Installer Manual
30
 KEYPADS
 COMMUNICATOR
 POWER SUPPLIES
 WIRED ZONES
 IN AND ZONES
 OUTPUTS
 AREAS
 SYSTEM FUNCTIONS
 SYSTEM TIMING
 SYSTEM TIMERS
 ACCESS CODES
 DATE/TIME
 HOLIDAY
 TEL NUMBER
 REMOTE SERVICE
 MONITOR STATION
 VOCAL MESSAGES
 SMS MESSAGES
 DIGITAL FORMAT
 TCP/IP NETWORK
 LOG EVENT
 2G/4G MODULE
 LANGUAGE
KEYPADS 1.21
After entering the Installer Menu, on the KEYPADS menu, press to enter the programming Step 1
mode.
Press and to select which keypad you want to program, and then press to enter Step 2
the programming mode.
By pressing + 2, you can enter the EDITING mode for changing the description of Keypad.
Configure the settings for the selected keypad. See Table 1-11. Step 3
Press and to alter the options. Press to confirm the setting and move to the next
submenu.
Table 1-11 Keypads programming settings
Submenu
Setting
STATE
ACTIVE: The keypad is operating.

ISOLATE: The keypad is out of use. For example, when the keypad has

technical problem or needs maintenance.