Alarm Control Panel Installer Manual
31
Establish on which Areas each keypad can control. Area 1 to Area 8 can be
assigned individually or in combination.
To assign or remove Areas from the keypad, press the corresponding key (1
to 8) and then press . The number of the assigned area appears on
the programming line to confirm that the selection was successful. The
number of the assigned area disappears from the programming line to
confirm that the de-selection was successful.
Select which areas (except those not assigned) status can be shown on the
LCD display. This function is used to display the status of the areas without
actually carrying out any operations on them.
Select which Areas the alarm events (Panic, Robbery, Fire, Medical, and
Duress) are sent to by pressing the corresponding key.
Duress can be sent by direct key or entry of the Duress code. If no area is
selected, the events described above cannot be activated.
To assign or remove Areas from the keypad, press the corresponding key (1
to 8) and then press . The number of the assigned area appears on
the programming line to confirm that the selection was successful. The
number of the assigned area disappears from the programming line to
confirm that the deselection was successful.
Determines to which Areas the tampering with the displayed Keypad
(opening of the case of anti-breach materials) must be sent.
If no area is assigned, tampering with the Keypad will not activate any
acoustic alarm.
To assign or remove Areas from the Keypad, press the corresponding key
(1 to 8) and then press . The number of the assigned Area appears on
the programming line to confirm that the selection was successful. The
number of the assigned Area disappears from the programming line to
confirm that the deselection was successful.
Select which Areas the alarm from a bus communication fault between the
keypad and the Control Panel must be sent to. In practice, an acoustic
alarm sounds when there is a loss of communication with the keypad
(interruption in communication between the keypad and the Control Panel).
If no Area is assigned, a keypad bus failure will not activate any acoustic
alarm.
To assign or remove Areas from the Keypad, press the corresponding key
(1 to 8) and then press . The number of the assigned Area appears on
the programming line to confirm that the selection was successful. The
number of the assigned Area disappears from the programming line to
confirm that the deselection was successful.
In the SYSTEM FUNCTION menu, you can then assign TAMPER or
TROUBLE type alarms to a specific sound mode (BUZZER, SIREN, both or
SILENT).
To Next Page
Loading...
